XD Forums banner
1 - 1 of 21 Posts

· Registered
14 Posts
My gunsmith dogs a machinist's vice into the tee-slots on his milling machine table. He clamps the pistol-slide into the vise and hand cranks the table to drive the slide and sight against a stationary piece of stock clamped in the tool head. He can easily move the sight (front or rear) a desired number of thousadths or drive it out entirely to replace it.

That's one expensive sight tool but it works if you have a Bridgeport in your garage.
1 - 1 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.